If your Whirlpool Cabrio washer is making a loud noise or vibrating excessively, it may be time to replace the bearings. This is a common repair that can be completed in a few hours with the right tools and instructions.
Table 1: Tools and Materials for Whirlpool Cabrio Washer Bearing Replacement
Tool/Material | Quantity |
---|---|
New bearing kit | 1 |
Socket wrench | 1 |
10mm socket | 1 |
13mm socket | 1 |
15mm socket | 1 |
Phillips screwdriver | 1 |
Flathead screwdriver | 1 |
Hammer | 1 |
Punch | 1 |
Grease | 1 tube |
Table 2: Step-by-Step Instructions for Whirlpool Cabrio Washer Bearing Replacement
Step | Instructions |
---|---|
1 | Unplug the washer from the power outlet and turn off the water supply. |
2 | Remove the back panel of the washer by removing the screws that hold it in place. |
3 | Locate the bearing housing, which is located at the bottom of the tub. |
4 | Remove the bolts that hold the bearing housing in place and remove the housing. |
5 | Remove the old bearings from the housing using a hammer and punch. |
6 | Grease the new bearings and install them in the housing. |
7 | Reinstall the bearing housing and tighten the bolts. |
8 | Reinstall the back panel of the washer and tighten the screws. |
9 | Plug in the washer and turn on the water supply. |
2024-08-01 02:38:21 UTC
2024-08-08 02:55:35 UTC
2024-08-07 02:55:36 UTC
2024-08-25 14:01:07 UTC
2024-08-25 14:01:51 UTC
2024-08-15 08:10:25 UTC
2024-08-12 08:10:05 UTC
2024-08-13 08:10:18 UTC
2024-08-01 02:37:48 UTC
2024-08-05 03:39:51 UTC
2024-10-15 19:57:53 UTC
2024-09-27 23:46:27 UTC
2024-08-01 19:48:19 UTC
2024-08-01 19:48:29 UTC
2024-08-02 18:00:29 UTC
2024-08-02 18:00:36 UTC
2024-10-20 01:33:06 UTC
2024-10-20 01:33:05 UTC
2024-10-20 01:33:04 UTC
2024-10-20 01:33:02 UTC
2024-10-20 01:32:58 UTC
2024-10-20 01:32:58 UTC