The 6001 bearing is a ubiquitous component in countless applications, including automotive, industrial, and household appliances. This deep-groove ball bearing offers a perfect balance of high performance, reliability, and cost-effectiveness. This extensive guide will delve into every aspect of the 6001 bearing, empowering you with the knowledge to optimize its use in your projects.
The 6001 bearing finds applications in a vast array of industries and products, including:
Consider the following factors when selecting a 6001 bearing:
Story 1:
A manufacturing plant experienced frequent failures of 6001 bearings in their electric motors. After thorough investigation, it was discovered that the bearings were not properly lubricated during installation, leading to excessive friction and premature wear. The plant implemented a strict lubrication maintenance schedule, resolving the bearing failure issue and significantly increasing motor reliability.
Story 2:
A technician was installing a 6001 bearing in a conveyor system. However, due to haste, the bearing was not correctly aligned with its mating components. This misalignment caused excessive vibration and noise, leading to premature bearing failure and downtime. The technician learned the importance of careful installation and proper alignment.
Story 3:
A household appliance manufacturer had been using an inferior grade of 6001 bearing in their washing machines. This resulted in numerous customer complaints due to excessive noise and vibration. After switching to a higher-quality bearing from a reputable manufacturer, the noise levels were drastically reduced, and customer satisfaction soared.
Material | Rating |
---|---|
Stainless Steel | 300 Series |
Carbon Steel | Grade 10 |
Chrome Steel | 52100 |
Ceramic | 99.9% Alumina |
Surface Roughness | Measurement |
---|---|
Ra: Average Roughness | 0.1 - 0.3 µm |
Rz: Maximum Height of Roughness | 2 - 6 µm |
Rt: Maximum Depth of Roughness | 4 - 12 µm |
Contact Angle | Angle (Degrees) |
---|---|
0° | Radial Contact |
15° | Angular Contact |
40° | Tapered Contact |
Maximize the performance and longevity of your equipment by selecting the right 6001 bearing and following the recommended operating practices. Utilize this comprehensive guide as a valuable resource to optimize the use of this versatile component.
2024-08-01 02:38:21 UTC
2024-08-08 02:55:35 UTC
2024-08-07 02:55:36 UTC
2024-08-25 14:01:07 UTC
2024-08-25 14:01:51 UTC
2024-08-15 08:10:25 UTC
2024-08-12 08:10:05 UTC
2024-08-13 08:10:18 UTC
2024-08-01 02:37:48 UTC
2024-08-05 03:39:51 UTC
2024-08-23 11:53:57 UTC
2024-08-23 11:54:10 UTC
2024-08-23 11:54:30 UTC
2024-08-23 11:54:47 UTC
2024-08-27 00:33:30 UTC
2024-10-19 01:33:05 UTC
2024-10-19 01:33:04 UTC
2024-10-19 01:33:04 UTC
2024-10-19 01:33:01 UTC
2024-10-19 01:33:00 UTC
2024-10-19 01:32:58 UTC
2024-10-19 01:32:58 UTC